Automotive Accessories

Jeep Builder Creates a Cut-Rate Rear Portal Axle by Flipping the Differential

A Ford 9-inch housing, Humvee geared hubs and off-the-shelf adapters deliver portal-axle clearance for roughly a fifth of the usual price — on the rear axle only.

Astrid BerglundNovember 17, 20265 min read0 views
A concept illustration of a modified off-road SUV rear axle mounted with its differential housing upside down and geared hubs at the wheels, shown in a workshop with a bucket-sized obstacle beneath it.

Portal axles are among the most sought-after upgrades in hardcore off-roading, and among the most expensive: a typical set from a specialist supplier such as 74Weld runs around $20,000. Zeph Gage's version costs about a fifth of that, largely because it is assembled from salvaged and off-the-shelf components — and because he fitted just one, on the rear of his Jeep.

What portal axles buy, and why they cost so much

The principle is straightforward. Instead of driveshafts and differentials hanging low beneath the transmission and transfer case, a portal setup puts a stack of reduction gears behind each driven wheel. The axle tubes can then sit high in the chassis, so very little hardware hangs below the frame rails. Paired with tall tires, the result is a large gain in ground clearance and a drivetrain that is far less likely to drag on rock or lava. The engineering and low-volume machining behind those gearboxes are what push prices into five figures.

Reversing the rotation instead of redesigning the axle

Gage's assembly combines a Ford 9-inch axle housing, geared hubs taken from a Humvee, and a set of Jesse Haines Fabrication HMMWV portal adapters. The complication is direction: two-gear portals of the Humvee type reverse the rotation of the input shaft. Rather than engineer around that, Gage simply flipped the differential upside down so the driveline spins the correct way, then bolted a Yukon Gear and Axle third member to it — in effect turning low-pinion parts into a budget high-pinion unit.

The arrangement does more than lift the rear by about six inches. It also preserves full shock travel, something the builder says is hard to achieve with portal axles, while reducing stress on the differential itself — a combination he expects to be effectively bulletproof.

Why the front axle stays conventional

Fitting a portal at the back without matching it up front is a familiar trick in the remote-control rock-crawler scene. Keeping the solid front axle means Gage avoids the packaging constraints that typically appear when portals are added to a vehicle that never left the factory with them. He also avoids cutting shock travel to make room, and the ride height does not end up absurdly tall.

Hand-fabricated hardware and the payoff

This is not an off-the-shelf kit. Gage produced his own brackets and custom-tapped plates, and paired a two-piece brake rotor with a Ford Fusion caliper — chosen partly because it incorporates an electric parking-brake solenoid and partly, again, for clearance.

The finished Jeep XJ can drive over a five-gallon bucket and still have several inches of clearance to spare, so the rear end will not hang up on obstacles the front end can simply steer around. Gage explains further details, including how he matched gearing front and rear, in a video from Outdoor Auto.