Researchers in China have investigated why screen printing can degrade copper-plated silicon heterojunction (HJT) solar cells and have proposed a modified screen design to reduce the damage. The work focuses on the photoresist-printing step used in copper plating, where the screen can contact the wafer across the full area rather than only at narrow fingers.
In HJT cells, the passivating contact structures are sensitive to mechanical stress and thermal treatment. Screen printing is widely used for metallization, but the pressure and handling involved can increase recombination losses and lower conversion efficiency. The issue matters for copper plating because it is seen as a route to cut silver use and metallization cost.
The study’s corresponding author, Lang Zhou, and colleagues examined prior production investigations that recorded a fall in conversion efficiency from 26.2% to 25.7% over 15,000 consecutive printing cycles. Open-circuit voltage and fill factor accounted for most of the loss, while short-circuit current density and electrical resistance remained largely unchanged. Minority-carrier lifetime degradation rose from 0.61% with a new screen to 11.0% after 15,000 cycles.
Using three-dimensional confocal microscopy, the researchers traced the decline mainly to progressive wear of the screen mesh knuckles. As the knuckles wore, their contact area with the wafer grew, increasing mechanical stress on the passivation layers beneath. Scanning electron microscopy showed no visible surface scratches, but photoluminescence measurements indicated higher recombination losses, pointing to damage at the amorphous silicon/crystalline silicon interface.
Zhou said the photoresist screen differs from a conventional silver-paste screen. In silver printing, screen openings cover only 2–5% of the area and an emulsion layer keeps the mesh from directly touching the wafer. Full-area photoresist coating typically uses a screen without emulsion coverage to spread resist uniformly, so the mesh contacts the wafer extensively during every print.
To prevent that contact, the researchers added an emulsion buffer layer to the screen. They tested six patterns with emulsion coverage ratios from 2.9% to 16.6%. Higher coverage protected the wafer but disrupted photoresist distribution, creating a trade-off between mechanical protection and coating uniformity.
A 4.7% emulsion coverage ratio gave the best balance in their tests. After 10,000 printing cycles, minority-carrier lifetime degradation was limited to 0.41%, while coating uniformity remained relatively good. The researchers attributed the improvement to the buffer layer keeping the mesh away from the wafer and reducing cumulative mechanical damage to the passivating contacts.
“The findings demonstrate that a relatively simple modification to screen design can substantially mitigate printing-induced degradation, offering a practical approach to improving the manufacturing reliability of copper-plated HJT solar cells,” Zhou said.
The results were published in Solar Energy. They come as copper metallization attracts more attention as a silver alternative for HJT. In April 2026, Nankai University researchers reported a silver-free HJT cell with 25.2% efficiency using plasma-induced interface engineering and copper electroplating. Separately, Germany’s Forschungszentrum Jülich achieved 23.08% with a fully copper-metallized HJT cell; a version with silver-copper paste on the front and silver contacts on the rear reached 23.95%.
The study presents a mitigation strategy rather than evidence of mass-production adoption. Its contribution is to identify a wear mechanism and demonstrate a lower-damage screen design at high cycle counts, while leaving open the need to optimize resist uniformity and long-run reliability.
